Parting out most of my 1982 rabbit convertible including the front end sheet metal for round headlight conversion or rust repair to the strut towers.$300
I have a full set of reupholstered (non-oem) seats $100 for the set
Plastic euro bumpers (with blinkers, clips and stainless mounting bolts $175
Tt tuning stainless downpipe + shift lever $200 (brand new, goes for $300 new)
mk1 (pacesetter?) header with large outlet $25

100mm a-arm assemblies from 89 cabriolet (comes with new ball joints, brakes and new brake lines, new tie rod ends) $100
If entire ABA/020 swap is purchased for $350 I'll throw in everything below.
Refreshed/rebuilt ABA engine (~120-150k on short block)
-Fresh belts, gaskets, oil, plugs, plug wires, ecu to match, water pump, cap, etc. etc.
- VR6 water pump pulley
-020 5 speed
-Fresh fluid, new (sach?) Clutch
- poly engine mounts
- both axles
- 100mm a-arms
- spindles(new ball joints)
- brake calipers and rotors (new brake lines)
- poly a-arm bushings (new)

I have a bunch of other parts available too, just ask. (gas tank, fuel filler neck with cap, rear beam axle assembly with new poly bushings, trunk cover lid, etc. etc.

things not available:
dashboard or knee bolster
steering column