VW R32 VF Engineering Stage 2 Supercharger setup

[nurtechnik]

I currently have the VF Stage 2 setup on my 04 R32. It runs 5-6psi depending on temperature and dynoed at 278awhp. Im looking for someone to trade their stock components for my setup. If possible I would have the other vehicle dropped off at my shop (Nur Technik) for a weekend and we could swap all necessary parts. The kit has approx 15k miles on it and runs great! MSRP was $6000 plus tax and install cost.

Asking $4500 installed on your car

[Hoffasenior]

Take payments? J/K Wish I could afford it at this time. Good luck with the sale.

[Casanova]

Hey, that's Bob's old R. I remember being in the shop when he installed that kit. I drove it once too. Very nice setup for a DD.

[Fearnside]

Noob question alert: The R is a 24v right? Should fit any 24v VR?

[Rowland]

278whp? weak

arent r32's like 270 to the crank stock?

[BimmerTim]

240hp crank. I'd bet that is putting 330-340hp to the crank.

[Fearnside]

278whp? weak

arent r32's like 270 to the crank stock?

I'll take that over the 170 crank of that passat... (I can say this as I owned a B5.5 for a couple years).

[Rowland]

.

[FlynnA4]

VF is a sweet company!

Dyno numbers are so hard to go by... depends on the temp, humidity, what dyno its on, how many fans are going (this can make a huge difference... if you arent atleast replicating the air flow you would be getting while driving, it can be a dissapointing run) etc..

looks like the VF website says 350hp, so his numbers are probably pretty accurate being that it was done at DB's. these things have so much torque, and area under the curve since its supercharged as opposed to turbo'd, it feels faster than the same amount of power out of a 1.8t with a big turbo, and much smoother to drive.

I believe there is a race gas file too, which brings it to 400hp/330 tq