Search:

pulled the valves and cams out of the vr6 head in order for it to be resurfaced.

anything people?

change out the valve that is stuck. you must have ran the engine low on oil.

I am looking for some lightly used upper and lower coolant hoses from the radiator for my VR6. thank you.

where are you located?

Sent you a pm about a few mk3 parts.

Highpainkiller where is that oil pump that I purchased from you. I sent to money a week ago.

anything?

Looking for some OEM rear shocks with some life in them for a MK3 golf.

Just asking, would you have a drivers side motor mount?

I am looking for a set of rear shocks for a MK3 Golf VR6 with some life in them. I do not need springs.

still looking.

as much as I would like one that is new, a used pump with some miles on it will be fine.

Looking for a oil pump for a VR6 motor. The previous owner that had this car must have hit a curb or something. It pushed the front end of the oil pan in and cracked the inlet screen in half. If...

your car is looking good.

I am assuming this is for a MK3.

installed tie rod ends,new boots for tie rods, ball joints, new rotors, new brake pads, freshly painted calipers.

This is going to start turning into a technical discussion. Which would you recommend? I have had a techtonics in the past but it was for a 2.0L. I believe that was techtonics with flow master.

anybody else? Does not necessarily have to be factory just not loud and drony.

I like supersprint but it probably won't work.