Search:

All of the driver's gear is provided by a local business! RaceSuitRental.com He owns a stg2 S4 avant, races a Spec Racer Ford, races Porsche 944 chump cars.

you most likely don't need an exact match; most any odbII will work. I have a couple...$30

That side mount cooler is from a VR6? For coolant? Where did it come from? I have only heard of these things. Do you have the hoses to go with it? I gotta assume there is some special plumbing...

DANGIT!!!!! I would have taken these....

what was the original cause for the salvage title?

Are you ready to get down and dirty? It's been two years, but we're heading back to the Isanti County Fairgrounds! Located in Cambridge, this site has been good to us in the past, with a nice tacky...

what code is on the transmission? miles/condition/type of car it came from?

How soon do you need it.....I have my long block that is in the process of being removed that had detonation on the rear 3 cylinders.

from the pic, the shell looks pretty clean.....almost to nice to crush....I thought about doing the same thing....chopping it right at the firewall or at the b-pillar, however both of those have...

I am sure I do; I live in st. Louis park.

I will be w/ JAB again this year... '90 GTI w/ ABA swap.
http://imageshack.us/scaled/thumb/718/23581378.jpg

how are you getting more air into it?
what makes you think it is lean?
since this is to be a lemons/chump racer the 034efi kit is out of the question, unless you can find a "used" one.
I'd get...

loop it....and get that ducting constructed, i'd do engine side, top, and bottom.

Just by a new one from Techtonics...they are like $300. any oem mkIII exhaust from this area is going to be a rusty POS and will cause you more time & frustration that it is worth.

disconnect the bottom rad. hose, then dump water into where the heater core was...see if the water makes it through the system. Drill a 1/16" hole in your thermostat to prevent a blockage (replace...

http://imageshack.us/a/img39/3064/imag0446x.th.jpg
$100, snow tires are barely legal

on older ABA's I generally put lower low pressure sender in, it is either off of a TDI or VR6, i forget which.
Part of the buzzer warning system is in the guage cluster, so it could be flakey. ...

Spacers will get you past the center bore issue...one would prolly need 8mm. If you want the center bore enlarged to 57.1mm for euro's call the Alignment Guy and ask jeff, he will put you in...

interesting; I had no idea there was a s/c awd model....

could be pump, but since it runs prolly not. figure out if it is a time thing, aka only after the car sits for 48hrs or so. Most likely it is a weak Fuel Pressure Regulator, or a check valve that...