DIY's for VW's Audi's and associated companies... etc
Note: I am not responsible for any wrong doing on your car if you do not use the specified vw special tools. This is just a picture guide for those...
So I found my front lines cracked pretty bad, and the car has 116k on the clock. Time to do the brake rubber lines. Tools needed 17mm 1/2...
I needed to replace my rear brakes on my mk5 jetta 2.5 so I figured I would write up a little DIY on how to do it. Its pretty straight forward as far...
Figured I would post this up to help anyone looking to do the same. There were no instructions provided, and nothing found on this on VW Vortex, but...
I apologize in advance for the over sized pictures Iv heard some guys breaking your TT cover trying to get it off. I have been wanting to take mine...
This is a small DIY on how to create the 2.9 clone intake manifold for the obd1 and obd2 vr6 engines. This guide will take you from the stock...
Given the "cutting shifter" posts and all that, I felt I had to take some type of leap. Take 1 stock shifter lever. And two chunks of metal, same...
So these came with my E-Codes a year or so ago and I just found them when cleaning out my desk and figured I'd scan it before recycling it for anyone...
repost... oopsies... http://eurowerks.org/showthread.php?t=11964
diy for yall start with ur jetta light separate the lense form the housing i found if u can heat gun the glue so its soft, wedge it apart...
So, I went into Burnsville VW a couple weeks ago to have them fix the center console air diffuser rattle in my car. Sadly, after around for a bit, I...
Whatever the reasons, sooner or later you will be replacing the struts on your VW, and you might even be putting some new springs in as well....
the B6 and B7 have the same suspension, so everything you see outlined here will work for your B7 too. *** NOTE: The procedures outlined here...
After missing my a6 hids I decided to call santa. Santa came early but I was too lazy to install till today. Bought the kit from ben @ direct...
So I was only getting a charge of 13.8v on my car. Spec is 13.8-14.2 and when I turned on heated seats and headlights and fan it would charge 13.6....
So I got sick of my sloppy whore shifter and bought a sloppy shifter rebuild kit from http://www.dieselgeek.com for 33.00shipped! I did it in my shop...
What does the Diode Mod do? The MAP (manifold absolute pressure) sensor is what reads how much actual boost you are making It sends that signal to...
So, my Passat came with a single din radio that just had togo. My original setup came with the HVAC controls on top, radio in the middle, and pocket...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules